|
Home WiFi Family Brochures Services Sensors Repeaters Receivers Web Servers Wireless Output Modules Wireless I/O XRPS Family People Counting Software Contact Support What's New About |
 |
 |
418 MHz Receiver The Point Six 418 MHz unit receives the RF signal from one or more wireless temperature or humidity transmitters which have a range of 100 feet. The receiver then outputs the values to any Analog Output Module through an RS485 four-wire bus. |
|
|
|
 |
418 MHz to 900 MHz Repeater The Point Six Repeater receives the 418 MHz RF signal from one or more wireless temperature or humidity transmitters which have a range of 100 feet. The Repeater re-transmits the signal at 900 MHz to a distance of 1000 feet to a BAPI 900 MHz Receiver. |
|
|
|
 |
900 MHz Receiver The Point Six 900 MHz unit receives a repeated or re-transmitted RF signal from one or more wireless temperature or humidity transmitters. The transmitter signal (418 MHz) is received by a Point Six Repeater and then re-transmitted at 900 MHz up to a 1000 feet to the 900 MHz Receiver. |
|
|
|
 |
Current Output Module (COM) The Current Output Module (COM) converts the data from the Wireless Receiver into a linear 4-20 mA signal for the DDC controller. |
|
|
|
 |
Resistance Output Module (ROM) The Resistance Output Module (ROM) converts the data from the Wireless Receiver into a Resistance for the DDC controller. The unit is factory calibrated to output a 10K-2 or 10K-3 thermistor curve. |
|
|
|
 |
Relay Output Module (RYOM) The Relay Output Module (RYOM) converts the data from the Wireless Receiver into a floating switch closure for the DDC controller. It is typically trained to the occupant override button on the side of the BAPI wireless temperature and/or humidity transmitter. |
|
|
|
 |
Voltage Output Module (VOM) The Voltage Output Module (VOM) converts the data from the Wireless Receiver into a linear 0-5 volt or 0-10 volt signal for the DDC controller. |
|
|
|