Point Six Wireless

Last updated July 31, 2009

Home

WiFi Family

Brochures

Services

Sensors

Repeaters

Receivers

Web Servers

Wireless Output Modules

Wireless I/O

XRPS Family

People Counting

Software

Contact

Support

What's New

About

Point Sensor Thermistor 900
900 MHz Transmitter

Main Features
  • 10K ohm thermistor transmitter (100K option)
  • Transmits thermistor data with unique ID
  • Integrated 100mw, 900 MHz SSFH radio for long range performance
  • Range Indoor: Up to 1300 feet
  • Range Outdoor: Up to 1 mile with standard antenna
  • Battery lasts up to 2 years with 5 minute transmit rate
  • Very small (3.25” X 3.25” X 1.375”) ABS Enclosure
  • Complies with part 15 of the FCC rules
  • CRC-16 error checked Status, ID and thermistor data
  • Conformal coated
  • External ¼ wave antenna

  • 900 MHz Transmitter
    Description:
    The Point Sensor Thermistor 900 wireless transmitter is a battery operated 10K ohm thermistor interface with a microprocessor controlled 900 MHz. FCC certified radio transmitter. The Point Sensor Thermistor 900 has an on board time of day clock that allows it to spend most of the time in a low power quiescent state. At predetermined time intervals the clock will wake up the onboard microprocessor and thermistor data is read from a 12-bit analog-to-digital converter. This information is combined with a unique serial ID, CRC-16 error check and transmitted in a very short data packet that results in a very short transmitter on-time. This architecture allows the Point Sensor Thermistor 900 to consume very little energy and a battery life of up to 2 years.

    The Point Sensor Thermistor 900 electronics are coated with a conformal material that provides a moisture barrier against condensation. Submersion in water is not recommended. An internal reed switch permits a user to activate the service switch with a magnet. A quick swipe of a magnet across the “Service” label will activate the service switch. When you perform this operation, a data transmission occurs immediately and a special mark is introduced in the ID field of the transmitted data packet to indicate which sensor is in service or installation. The Sensor is shipped with the transmitter turned off (anytime the Sensor is to be shipped the transmitter should be turned off or must be placed in a shielded container to prevent interference that might cause shipping problems). The sensor is started by sliding the On/Off Switch towards the SMA antenna connection. The Point Sensor Thermistor-900 sensor can be turned off by sliding the On/Off switch away from the SMA antenna connection.


    Technical Features:
    Transmission rate Preprogrammed at factory (5 minutes default)
    Shelf life with battery installed 10 Years in quiescent mode
    Dimensions (enclosure) 3.25 W X 3.25 H X 1.375 D (inches)
    Weight 4.7 oz.
    Operating Temperature -40° to 85° C
    Humidity 0% to 90% non-condensing
    Input 10Kohm thermistor
    Battery life with transmissions 2 years with TX period of 5 minutes
    Battery (2) 3.6 volt Lithium thionyl chloride
    FCC Certified FCC ID: OUR9XSTREAM



    Axon Return